The zipper pull of the head of the card phenomenon usually occurs in the following circumstances:

1, zipper in the switch, sometimes due to pull the first clip to the zipper so that the movement may not move. At this point if the blindly strong pull zipper, will only make the cloth card more tight, so as far as possible to pull the card in the pull out of the cloth and pull back to the original position, if completely stuck, then, not too Force, as long as you can slowly pull up. Also be careful when sewing zipper sewing flat.

2, wear, undress, please zipper completely open the case of re-wear, off, it is best to first button or trousers hook and then the zipper will be more smoothly, if the pull head stopped in the chain half of the teeth, it is easy Resulting in zipper solid barrier. Zippers with long boots, gloves and clothing items, but also pay more attention to reduce the trouble.

 

 

The zipper head of the kabu phenomenon usually occurs in the following circumstances:

1, the zipper switch, sometimes due to the zipper head clip to the zipper can not move. At this point if the blindly strong zipper. So that the cloth card was tighter, so as far as possible to pull the card in the pull out of the cloth and pull the head back to the original position, if completely stuck, then, not too hard, as long as slowly pull up can. In addition, sewing zipper should also pay attention to the formation of sewing.

2, wear, undress, please zipper completely open the case of re-wear, off, it is best to first button or trousers hook and then the zipper will be more smoothly, if the zipper stopped in the chain half of the teeth, it is easy Resulting in zipper solid barrier. Zippers with long boots, gloves and clothing items, but also pay more attention to reduce the trouble.

In addition, in daily life, we also know how to repair the simple zipper, the following Xiaobian gave you the next step:

1, first zipper top of a large tooth with pliers dial down, both sides have to dial.

2, then zipper head pulled to the top.

3, and then put the teeth on both sides together.

4, and then into the zipper headset (there is a certain degree of difficulty .If it is not into the set, put a small diameter cut on the radial line, remember, do not place a place in the cut, should rely on the top of the local cut, Not up).

5, put the big teeth, zipper headgear into after.

This zipper head installation is complete, very simple is it!